MXBON 695

MXBON 695 is a medium-low viscosity, fast curing single component Cyanoacrylate Adhesive. It is specifically formulated for the assembly of difficult to bond substrates, particularly suitable for bonding plastic or rubber parts, where very fast fixturing is required. MXBON 695 is a one-component, solvent-free system and does not require the use of a catalyst, heat or clamps. When a thin layer of MXBON 695 applied between two surfaces comes into contact with atmospheric moisture, a rapid polymerization occurs producing the ultimate bond.
DIRECTIONS FOR USE:
Make sure the surfaces to be bonded are clean and dry (preferable to solvent-wipe plastics, glass, and rubber, and to acid-treat metals).
Dispense a drop or drops to one surface only. Apply only enough to leave a thin film after compression.
Press parts together and hold firmly for a few seconds. Good contact is essential. An adequate bond develops in less than one minute. (Maximum strength is achieved in 24 to 48 hours).
Wipe off excess adhesive from the top of the container and recap
MXBON
®
695
if left uncapped, may deteriorate by contamination from moisture in the air.
Because
MXBON
695
condenses by polymerization, sometimes whitening will occur on the surface of the container or the bonded materials. Should this happen, wipe surfaces well with acetone.
HANDLING AND STORAGE:
Storage
:
Keep products in the unopened container in a cool and dry location. Best when stored at 2 to 8ºC.
Temperatures less than 2ºC can adversely affect product properties. Do Not Freeze. Keep container tightly closed until ready for use.
Handling:
Material removed from containers may be contaminated during use. Do not pour back any product to  the original container. Misuse of product will void all warrantees